Product Search

 

Top Searches

 

Price Match

Price Match
 

Secure Site

Secure Site
 

Hottest Products

 
You are here:  » Help and Support » Dyson Section » Dyson Technical Advice » DYSON DC08 Technical advice
image:Changing the Pre Motor Filter

Changing the Pre Motor Filter

1. Start by detaching your Dyson's cyclone/bin assembly.2. Then unlatch the pre motor filter cover.3. Underneath the cover you will find the blue/yellow pre motor filter. Which can now be removed.   4. Separate the blue sponge section from the outer yellow plastic carrier. Rinse both parts in warm soapy water and only refit to the Dyson when they have been dried thoroughly. Reass...

Read full article...

image:Changing the Post Motor Filter

Changing the Post Motor Filter

1. Start by detaching your Dyson's cyclone/bin assembly. 2. Then unlatch the pre motor filter cover. 3.Beneath the lid you will find, depending on the model, one of the following filters. Post Motor Filter Pad Post Motor HEPA Filter The fil...

Read full article...

image:Changing the Hose

Changing the Hose

1. Start by depressing the brightly coloured buttons located either side of the cuff on the wand assembly to release the hose....

Read full article...

image:Changing the Switch

Changing the Switch

1. Start by detaching your Dyson's cyclone/bin assembly. 2. Then unlatch the pre motor filter cover. 3. Underneath cover you will find the blue/yellow pre motor filter. Which can now be removed. 4. Remove the wheels by placing a large flat screwdriver into the gap between the DC08's body and the wheel. Ensure that the screwdriver is placed as close to the centre as possible before prising the w...

Read full article...

image:Changing the Wheels

Changing the Wheels

1. Remove the wheels by placing a large flat screwdriver into the gap between the DC08's body and the wheel. Ensure that the screwdriver is placed as close to the centre as possible before prising the wheel off.Reassembly is a simple matter of reversing the steps listed above.

Read full article...

image:Changing the Cable

Changing the Cable

1. Start by detaching your Dyson's cyclone/bin assembly.

Read full article...

image:Changing the Motor

Changing the Motor

1. Start by detaching your Dyson's cyclone/bin assembly.  2. Then unlatch the pre motor filter cover.   3. Underneath the pre motor filter cover you will find the blue/yellow pre motor filter. Which can now be removed.  4. Next remove the wheels by placing a large flat screwdriver into the gap between the DC08's body and the wheel. Ensure that the screwdriver is place...

Read full article...