Replacing the Brush Bar (Models WITH Brush Control)

PLEASE NOTE: If your are in anyway unsure of any of the steps listed below. Please consult a qualified electrician and always disconnect the Dyson from the mains before commencing work.

1. Lay your Dyson onto it's back and, using a two pence piece or a large flat screwdriver, turn each of the three soleplate fasteners a quarter of a turn in an anti-clockwise direction.

2. Remove the soleplate by pulling it away from the brush holder at the bottom edge.

3. Place the Brush Roll Removal Tool (Designed by and sold exclusively through www.sparesaver.com) over the brush bar at the belt end.

4. Using the belt hook, pull the belt onto the bottom holding pin of the Brush Roll Removal Tool. Then hook the belt onto the top pin.

5. Carefully pull the brush bar out of the brush holder. Then unhook the belt from the Brush Removal Tool and remove the tool.

Reassembly is a simple reversal of the steps listed above.