Product Search

 

Top Searches

 

Price Match

Price Match
 

Secure Site

Secure Site
 

Hottest Products

 
You are here:  » Help and Support » Dyson Section » Dyson Technical Advice » DYSON DC05 Technical Advice
image:Changing the Pre Motor Filter

Changing the Pre Motor Filter

1. Start by detaching the Dyson's cyclone top assembly.   2. Allow the Cyclone top assembly to rest on the floor then remove the blue & yellow pre motor filter from it's housing.   3. Remove the pre motor filter from it's housing and then seperate the blue sponge section from the outer ...

Read full article...

image:Changing the Post Motor Filter

Changing the Post Motor Filter

1. Start by detaching the Dyson's cyclone top assembly. ...

Read full article...

image:Changing the Hose

Changing the Hose

1. Firstly detach the hose from the bent wand by depressing the two brightly coloured buttons. Located either side of the cuff on the bent wand.   2. Detach the hose from the main body of your DC05 by withdrawing the hose from the inlet.   3. Then release the hose support by laying the Dyson onto it's side and depressing the...

Read full article...

image:Changing the Wheel

Changing the Wheel

1. Remove the wheels by placing a large flat screwdriver into the gap between the DC05's body and the wheel. Ensure that the screwdriver is placed as close to the centre as possible before prising the wheel off. ...

Read full article...

image:Changing the Cable

Changing the Cable

1. Start by detaching the Dyson's cyclone top assembly.   2. Then remove the cyclone /bin assembly.   3. Underneath the cyclone/bin assembly you will find the post motor filter lid. The lid is removed by pulling back the two locating tabs (arrowed).   4. Remove the post motor f...

Read full article...

image:Changing the Switch

Changing the Switch

1. Start by detaching the Dyson's cyclone top assembly.   2. Then remove the cyclone /bin assembly.   3. Underneath the cyclone/bin assembly you will find the post motor filter lid. The lid is removed by pulling back the two locating tabs (arrowed).   4. Remove the post motor f...

Read full article...

image:Changing the Motor

Changing the Motor

1. Start by detaching the Dyson's cyclone top assembly.   2. Then remove the cyclone /bin assembly.   3. Underneath the cyclone/bin assembly you will find the post motor filter lid. The lid is removed by pulling back the two locating tabs (arrowed).   4. Remove the post motor f...

Read full article...