Product Search

 

Top Searches

 

Price Match

Price Match
 

Secure Site

Secure Site
 

Quick Links

 
You are here:  » Help and Support » Dyson Section » Dyson Technical Advice » DYSON DC03 Technical Advice
image:Replacing the Pre Motor Filter

Replacing the Pre Motor Filter

PLEASE NOTE: Always remove the plug from the socket before commencing work. 1. Start by pushing the locating ring above the filter housing forward to release the filter housing.   2. Remove the filter housing by sliding it out from the main body.   3. After removing the pre filter from its hous...

Read full article...

image:Replacing the Post Motor Filter

Replacing the Post Motor Filter

PLEASE NOTE: Always remove the plug from the socket before commencing work. 1. Start by pushing the locating ring above the filter housing forward to release the pre motor filter housing   2. Remove the pre motor filter housing by sliding it out from the main body.   3. Carefully relea...

Read full article...

image:Replacing the Hose

Replacing the Hose

PLEASE NOTE: Always remove the plug from the socket before commencing work. 1. Start by removing the power cable from the rear of the Dyson and then detach the wand handle from the main body and allow the hose to lie on the floor. Next, at the bottom of the hose, pull in the tab at the rear.   2. Allow the cassette assem...

Read full article...

image:Replacing the Wheels

Replacing the Wheels

PLEASE NOTE: Always remove the plug from the socket before commencing work. 1. Start by laying your Dyson onto it's side and, using a thin flat bladed screwdriver, prise off the glamour cap (hub cap) from the wheel.   2. After removing the circlip holding the wheel onto the axle the wheel can be simply pulled off the axle. &...

Read full article...

image:Replacing the Brush Roll

Replacing the Brush Roll

PLEASE NOTE: Always remove the plug from the socket before commencing work.1. Start by laying your Dyson onto it's back and, using a two pence piece, turn each of the three soleplate fasteners a quarter of a turn in an anti-clockwise direction.   2. Remove the soleplate by prising it, underneath the centre soleplate fastener, away from the cleaner head. ...

Read full article...

image:Replacing the Cable

Replacing the Cable

PLEASE NOTE: If your are in anyway unsure of any of the steps listed below. Please consult a qualified electrician and always remove the plug from the socket before commencing work. 1. Start by unwinding the cable and then remove the wand assembly from the rear of the Dyson. Then, using the specially bent small screwdriver. gently push the screwdriver into the gap between the switch cove...

Read full article...

image:Replacing the Switch

Replacing the Switch

PLEASE NOTE: If your are in anyway unsure of any of the steps listed below. Please consult a qualified electrician and always remove the plug from the socket before commencing work. 1. Start by unwinding the cable and then remove the wand assembly from the rear of the Dyson. Then, using the specially bent small screwdriver. gently push the screwdriver into the gap between the switch cover and...

Read full article...

image:Replacing the Motor

Replacing the Motor

PLEASE NOTE: If your are in anyway unsure of any of the steps listed below. Please consult a qualified electrician and always disconnect the Dyson from the mains before commencing work. 1. Lay your Dyson onto it\'s back and, using a two pence piece, turn each of the three soleplate fasteners a quarter of a turn in an anti-clockwise direction. ...

Read full article...